-
Hydraulic Manifolds vs O-Ring Grooves: which one fits your part
Hydraulic Manifolds is a block with drilled and ported passages that connects valves, pumps and actuators It is used for replacing pipework with a single machined block, in mobile and industrial hydraulics. Typical value
Details -
Mould Inserts vs O-Ring Grooves: which one fits your part
Mould Inserts is a replaceable steel component that forms part of a mould cavity It is used for moulds where a wear area, a core or a detail needs to be replaced or machined separately. Typical values: material H13, or a
Details -
Ti-6Al-4V Titanium vs C3604 Brass: which one fits your part
Ti-6Al-4V Titanium is the standard titanium alloy, with aluminium and vanadium, used where weight and corrosion matter It is used for aerospace structures, medical implants and high performance parts. Typical values: ten
Details -
Duplex 2205 Stainless Steel vs Inconel 718: which one fits your part
Duplex 2205 Stainless Steel is a two phase stainless steel with roughly equal ferrite and austenite It is used for parts that need high strength and resistance to chloride stress corrosion. Typical values: tensile streng
Details -
Deep Hole Drilling vs Reaming and Boring: which one fits your part
Deep Hole Drilling is drilling holes deeper than about ten times the diameter, with guided tools and high pressure coolant It is used for cooling channels, hydraulic bores and long oil ways that cannot be reached with a
Details -
4140 Alloy Steel vs Inconel 718: which one fits your part
4140 Alloy Steel is a chromium molybdenum alloy steel used in the quenched and tempered condition It is used for shafts, gears and high strength parts that are heat treated after rough machining. Typical values: tensile
Details -
PEEK vs C3604 Brass: which one fits your part
PEEK is a high performance thermoplastic that holds its properties at temperature and resists chemicals It is used for parts that have to work where a metal corrodes or where weight and insulation matter. Typical values:
Details -
O-Ring Grooves vs Bearing Housings: which one fits your part
O-Ring Grooves is a groove that locates and compresses an elastomer seal between two faces It is used for any assembly that has to hold pressure without a gasket or a sealant. Typical values: standard ISO 3601 for the gr
Details -
Splined Shafts vs Bearing Housings: which one fits your part
Splined Shafts is a shaft with a series of ridges that transmit torque to a mating hub It is used for drive applications where a keyway would be too weak or would need an accurate fit. Typical values: common forms involu
Details -
Bearing Housings vs O-Ring Grooves: which one fits your part
Bearing Housings is a bore and shoulder arrangement that locates a rolling bearing and keeps it square It is used for rotating assemblies where the bearing position sets the shaft alignment. Typical values: bore toleranc
Details
Search:
