-
Surface finish achievable with CNC Milling
CNC Milling is a cutting process where a rotating multi tooth tool removes material from a stationary workpiece It is used for producing flat faces, pockets, slots and contoured surfaces on prismatic parts. Typical value
Details -
Surface finish achievable with Hard Milling
Hard Milling is milling material in its hardened state, usually above 45 HRC, with coated carbide or ceramic tools It is used for finishing hardened tool steel and bearing steel without grinding or EDM. Typical values: h
Details -
Surface finish achievable with High Speed Machining
High Speed Machining is milling at high spindle speed with light radial engagement and high feed per tooth It is used for removing metal quickly from thin walled or difficult parts with low cutting force. Typical values:
Details -
Surface finish achievable with Swiss-Type Lathe
Swiss-Type Lathe is a sliding headstock lathe where the bar is supported close to the cutting point by a guide bushing It is used for long, slender turned parts where the length to diameter ratio defeats a conventional l
Details -
Surface finish achievable with CNC Turning
CNC Turning is a cutting process where the workpiece rotates and a single point tool removes material It is used for producing diameters, faces, grooves and threads on rotational parts. Typical values: typical tolerance
Details -
Surface finish achievable with Deep Hole Drilling
Deep Hole Drilling is drilling holes deeper than about ten times the diameter, with guided tools and high pressure coolant It is used for cooling channels, hydraulic bores and long oil ways that cannot be reached with a
Details -
Surface finish achievable with Honing
Honing is an abrasive finishing process that uses expanding stones to correct bore geometry It is used for holding roundness, straightness and a controlled surface pattern in a bore. Typical values: diameter range 5 to 5
Details -
Surface finish achievable with CNC Drilling Machine
CNC Drilling Machine is a machine dedicated to producing holes, with a spindle feed and often a multi spindle head It is used for production drilling, tapping and countersinking on parts with many holes. Typical values:
Details -
Surface finish achievable with Turn-Mill Centre
Turn-Mill Centre is a lathe with driven tooling and a Y axis, so milling and turning are completed in one machine It is used for complex parts that would otherwise move between a lathe and a machining centre. Typical val
Details -
PPAP Submission setup, maintenance and daily checks
PPAP Submission is the production part approval process used in the automotive supply chain, at four levels of evidence It is used for proving that a production process can make the part repeatedly, before series supply
Details
Search:
