-
How to specify Inconel 718 on a drawing
Inconel 718 is a nickel chromium super alloy that holds strength at high temperature It is used for turbine, downhole and high temperature parts where creep and oxidation set the limit. Typical values: tensile strength 1
Details -
How to specify C3604 Brass on a drawing
C3604 Brass is a free cutting brass with lead, the standard choice for turned parts that have to be fast to make It is used for fittings, connectors and turned components where machinability drives the cost. Typical valu
Details -
How to specify 2024-T3 Aluminium on a drawing
2024-T3 Aluminium is an aluminium copper alloy in the T3 temper, known for fatigue resistance It is used for aerospace sheet and plate parts where the load cycles rather than sits. Typical values: tensile strength 483 MP
Details -
How to specify Duplex 2205 Stainless Steel on a drawing
Duplex 2205 Stainless Steel is a two phase stainless steel with roughly equal ferrite and austenite It is used for parts that need high strength and resistance to chloride stress corrosion. Typical values: tensile streng
Details -
How to specify PEEK on a drawing
PEEK is a high performance thermoplastic that holds its properties at temperature and resists chemicals It is used for parts that have to work where a metal corrodes or where weight and insulation matter. Typical values:
Details -
How to specify 4140 Alloy Steel on a drawing
4140 Alloy Steel is a chromium molybdenum alloy steel used in the quenched and tempered condition It is used for shafts, gears and high strength parts that are heat treated after rough machining. Typical values: tensile
Details -
How to specify Splined Shafts on a drawing
Splined Shafts is a shaft with a series of ridges that transmit torque to a mating hub It is used for drive applications where a keyway would be too weak or would need an accurate fit. Typical values: common forms involu
Details -
How to specify O-Ring Grooves on a drawing
O-Ring Grooves is a groove that locates and compresses an elastomer seal between two faces It is used for any assembly that has to hold pressure without a gasket or a sealant. Typical values: standard ISO 3601 for the gr
Details -
How to specify Ti-6Al-4V Titanium on a drawing
Ti-6Al-4V Titanium is the standard titanium alloy, with aluminium and vanadium, used where weight and corrosion matter It is used for aerospace structures, medical implants and high performance parts. Typical values: ten
Details -
How to specify 17-4PH Stainless Steel on a drawing
17-4PH Stainless Steel is a precipitation hardening martensitic stainless steel, used in the H900 condition for strength It is used for parts that need the corrosion resistance of stainless with the strength of an alloy
Details
Search:
