A Bed Type Milling Machine removes material with a rotating cutter, producing pockets, slots, contours and three dimensional surfaces. The Bed Type Milling Machine described here is built with a 3-axis configuration and 10,000 rpm spindle and specified for aerospace suppliers. CNC milling with adaptive roughing and finish passes sits behind the numbers below, which are stated as delivered rather than as a best case.
The parts that matter most are the interfaces: bores, sealing faces, threads and mounting patterns. Those are held to ±0.02 mm, verified against the drawing, and recorded before anything is packed.
Specification
| Process | Cnc milling with adaptive roughing and finish passes |
|---|---|
| Material / configuration | a 3-axis configuration and 10,000 rpm spindle |
| Size / capacity | 1200 × 600 mm table |
| Tolerance | ±0.02 mm |
| Surface finish | milled finish, Ra 0.8–3.2 µm |
| Application | bed type milling machine for aerospace suppliers |
| Inspection | Dimensional report, material certificate, first article report on request |
| Lead time | 7–15 working days for samples, 3–4 weeks for production |
| Minimum order | 1 piece for prototypes, from 50 pieces for production pricing |
Manufacturing process
The operation sequence is decided before the first chip is cut: roughing to leave even stock, semi-finishing, then CNC milling with adaptive roughing and finish passes as the final operation. That order is what keeps ±0.02 mm stable as the batch runs and the machine warms up.
Material is purchased against a certificate and checked on receipt, so the composition is known before any cutting starts. Work in progress is identified by part number and operation, and the finished parts are deburred, cleaned and protected before they leave the machine area.
Typical applications
Most of the work supplied in this category falls into the following examples.
- Mould and die cavities.
- Machine base plates.
- Aerospace ribs and spars.
- Impeller and blisk roughing.
- Instrument panels and enclosures.
Quality control and documentation
Every batch is measured against the drawing with calibrated equipment, and results are recorded against the part number rather than kept on a scrap of paper.
Material certificates to EN 10204 3.1, dimensional reports and first article inspection reports are issued with the shipment where the application requires them. Calibration dates and measurement uncertainty are recorded alongside every result.
Ordering, lead time and packaging
Quotations are returned within one working day of a complete drawing package. Lead time is quoted from drawing approval, not from the date of enquiry.
Frequently asked questions
What is the difference between 3, 4 and 5 axis?
Three axis machines cut prismatic parts; a fourth rotates the part for features around a cylinder; five axis tilts the cutter or table so compound angles are reached in one setup.
How is surface finish controlled?
By the stepover, the cutter geometry and the final finishing pass. Ra 1.6 µm is routine, and Ra 0.8 µm is achieved with a fine stepover and a sharp, balanced tool.
Do you keep tooling and programmes for repeat orders?
Fixtures, tool lists and verified CAM programmes are retained for the life of the part number, so a repeat release runs on the same setup as the first batch without a new proving run.
To discuss bed type milling machine requirements, send the model and the drawing with the quantities required. Feedback on manufacturability is given free of charge before any order is placed.
