A Tube Laser Cutting Machine turns flat sheet into accurate blanks without any tooling, which is why it suits both one-off parts and repeat batches equally well. This page covers the Tube Laser Cutting Machine configured with a 3 kW fibre source and 1500 × 3000 mm bed and supplied to industrial enclosures: CNC fibre laser cutting with automatic nesting and height sensing. The headline figure is cutting 1–20 mm carbon steel, and the rest of the page explains what it means in daily use.
In practice the difficulty is rarely the nominal size. ±0.1 mm is held on the features that locate the part in the assembly, and the process is set up so that the first piece and the five hundredth measure the same way.
Specification
| Process | Cnc fibre laser cutting with automatic nesting and height sensing |
|---|---|
| Material / configuration | a 3 kW fibre source and 1500 × 3000 mm bed |
| Size / capacity | cutting 1–20 mm carbon steel |
| Tolerance | ±0.1 mm |
| Surface finish | clean cut edge, dross-free on thin gauge |
| Application | tube laser cutting machine for industrial enclosures |
| Inspection | Dimensional report, material certificate, first article report on request |
| Lead time | 7–15 working days for samples, 3–4 weeks for production |
| Minimum order | 1 piece for prototypes, from 50 pieces for production pricing |
Manufacturing process
Production begins with a drawing and material review. Stock is certified, the operation sequence is fixed, and CNC fibre laser cutting with automatic nesting and height sensing is carried out on equipment maintained to hold ±0.1 mm over a full shift, not just on a first piece.
Material is purchased against a certificate and checked on receipt, so the composition is known before any cutting starts. Work in progress is identified by part number and operation, and the finished parts are deburred, cleaned and protected before they leave the machine area.
Typical applications
Most of the work supplied in this category falls into the following examples.
- Machine guards and access panels.
- Enclosure panels and brackets.
- Chassis and frame plates.
- Architectural and decorative screens.
- Equipment racks and shelves.
Quality control and documentation
Inspection is not a final formality. Dimensions are checked during the cycle and again at the end, so drift is corrected while there is still stock to remove.
Material certificates to EN 10204 3.1, dimensional reports and first article inspection reports are issued with the shipment where the application requires them. Calibration dates and measurement uncertainty are recorded alongside every result.
Ordering, lead time and packaging
Orders start from a single piece. Samples are quoted from the 3D model, and production pricing follows once quantity, finishing and inspection are agreed.
Frequently asked questions
What thickness can a fibre laser cut?
A 3 kW source cuts up to 12 mm carbon steel and 6 mm stainless steel cleanly; 6 kW reaches 20 mm carbon steel, and 12 kW sources handle 25 mm plate in production.
Is there a heat affected zone?
Yes, but it is small: typically 0.1 to 0.3 mm on the cut edge, and it is removed by a light grind where the part is welded or fatigue loaded afterwards.
How long does delivery take?
Sample parts are typically shipped in 7 to 15 working days after drawing approval. Production batches run 3 to 4 weeks depending on quantity, finishing and inspection requirements.
Send the drawing or the 3D model for a quotation. Include material, quantity, tolerance and finish, and a detailed quote with lead time is returned within one working day.
