A C110 copper nozzle is used where conductivity, corrosion resistance and a clean machined finish matter without heat treatment. C110 copper nozzle for robotics work is produced here with high speed turning and milling of free-cutting brass and copper. The sections below describe what is held on the drawing, how the part is made and what arrives with the shipment.
The parts that matter most are the interfaces: bores, sealing faces, threads and mounting patterns. Those are held to ±0.02 mm, verified against the drawing, and recorded before anything is packed.
Specification
| Process | High speed turning and milling of free-cutting brass and copper |
|---|---|
| Material / configuration | C110 copper |
| Size / capacity | Ø 20 mm × 60 mm |
| Tolerance | ±0.02 mm |
| Surface finish | as machined, polished or plated |
| Application | nozzle for robotics |
| Inspection | Dimensional report, material certificate, first article report on request |
| Lead time | 7–15 working days for samples, 3–4 weeks for production |
| Minimum order | 1 piece for prototypes, from 50 pieces for production pricing |
Manufacturing process
The operation sequence is decided before the first chip is cut: roughing to leave even stock, semi-finishing, then high speed turning and milling of free-cutting brass and copper as the final operation. That order is what keeps ±0.02 mm stable as the batch runs and the machine warms up.
Material is purchased against a certificate and checked on receipt, so the composition is known before any cutting starts. Work in progress is identified by part number and operation, and the finished parts are deburred, cleaned and protected before they leave the machine area.
Typical applications
Most of the work supplied in this category falls into the following examples.
- Plumbing and pneumatic fittings.
- Electrical terminals and contacts.
- Valve and pump components.
- Instrument and gauge bodies.
- Heat exchanger connectors.
Quality control and documentation
Every batch is measured against the drawing with calibrated equipment, and results are recorded against the part number rather than kept on a scrap of paper.
Material certificates to EN 10204 3.1, dimensional reports and first article inspection reports are issued with the shipment where the application requires them. Calibration dates and measurement uncertainty are recorded alongside every result.
Ordering, lead time and packaging
Quotations are returned within one working day of a complete drawing package. Lead time is quoted from drawing approval, not from the date of enquiry.
Frequently asked questions
Why is brass preferred for fittings?
It machines freely, holds pressure tight faces and threads, resists dezincification in the right grade and needs no protective coating in normal service.
Can copper be machined to close tolerances?
Yes, but it demands sharp tooling, generous coolant and controlled speeds because it is soft and tends to smear rather than cut cleanly.
Do you keep tooling and programmes for repeat orders?
Fixtures, tool lists and verified CAM programmes are retained for the life of the part number, so a repeat release runs on the same setup as the first batch without a new proving run.
To discuss nozzle requirements, send the model and the drawing with the quantities required. Feedback on manufacturability is given free of charge before any order is placed.
