PEEK FAQ: the questions buyers ask

PEEK is a high performance thermoplastic that holds its properties at temperature and resists chemicals. It is used for parts that have to work where a metal corrodes or where weight and insulation matter. This entry explains what it is, what the numbers on a data sheet mean, and what to put on a drawing.

It is written from the point of view of the buyer and the drawing office: the values that are realistic in production, the ones that cost money, and the way the result is verified. Where an industry sets the requirement, rail is used as the example: documented welds, coatings and fire smoke toxicity compliance.

The questions buyers ask

What is PEEK used for?

It is used for parts that have to work where a metal corrodes or where weight and insulation matter. A high performance thermoplastic that holds its properties at temperature and resists chemicals.

What tolerance can be held?

±0.05 mm, because of thermal expansion is typical, held on the features that carry the function and confirmed by dimensional inspection at 20 °C after stabilising.

Which material should be specified?

PEEK is the usual choice; the certificate requirement is material certificate with the batch.

What finish comes as standard?

Ra 0.8 µm achievable with sharp tools. A finer finish is a separate operation and is quoted as one.

How long does it take?

A realistic cycle is fast cutting, but with care on heat build up, and the cost driver is material cost is high per kilogram.

What information is needed for a quotation?

A STEP or IGES model and a PDF drawing with tolerances, material and finish called out, plus the quantity and the expected repeat frequency.

Can the same result be guaranteed on a repeat order?

Yes, because the fixtures, tool lists and verified programmes are retained for the life of the part number.

What is the most common mistake on the drawing?

Machining it with a steel cutting geometry, which melts rather than cuts.

Applications

PEEK is used for parts that have to work where a metal corrodes or where weight and insulation matter, and in practice it appears most often in semiconductor handling, medical devices, pump wear parts, insulators.

How it fits into a machining route

The route is fixed before the first part is cut, and it is the route rather than the individual setting that holds the result: material cost is high per kilogram. Where a drawing calls for something the route cannot hold economically, that is raised at quotation rather than after the parts are made.

Standards, documentation and what is issued

The documentation requirement is material certificate with the batch. Material is supplied against a certificate where the application calls for it, inspection results are recorded with the job, and the records are kept so that a repeat order can be compared with the first instead of being measured from scratch.

Dimensional inspection at 20 °C after stabilising is the verification step. Where a customer format or a standard report is required, it is agreed before the batch starts, because a report written after the event is a report nobody can use.

Frequently asked questions

What tolerance should be specified for PEEK?

±0.05 mm, because of thermal expansion is realistic in production. Tightening it beyond the functional requirement increases cost without improving the part.

Which material is usually used?

PEEK is the usual choice, supplied against material certificate with the batch.

How is the result verified?

Dimensional inspection at 20 °C after stabilising, with the results recorded so a repeat order can be compared with the first.

What is the most common mistake?

Measuring it straight off the machine, before it has cooled.

How long does it take and what does it cost?

A realistic cycle is fast cutting, but with care on heat build up, and the cost driver is material cost is high per kilogram.

Related capability

If you are specifying PEEK on a drawing and want a second opinion on the route, send the model and the quantity. The first response is a manufacturability review with the likely risk points and a quotation, so the decision can be made on facts rather than on a price alone.

Machining, inspection and documentation are handled in one place, which is why the dimensional report and the material certificate arrive with the parts rather than after them.

Related entries

These entries sit next to PEEK in the encyclopedia: Inconel 718, C3604 Brass, Heat Sinks. Reading them together gives a fuller picture of how the process, the material and the measurement affect each other.