Hard Milling inspection and measurement methods

Hard Milling is milling material in its hardened state, usually above 45 HRC, with coated carbide or ceramic tools. It is used for finishing hardened tool steel and bearing steel without grinding or EDM. This entry explains what it is, what the numbers on a data sheet mean, and what to put on a drawing.

It is written from the point of view of the buyer and the drawing office: the values that are realistic in production, the ones that cost money, and the way the result is verified. Where an industry sets the requirement, food processing is used as the example: surfaces that clean down between production runs.

How it is measured

CMM and roughness gauge. The equipment is calibrated, the uncertainty is recorded, and the part is at room temperature before the first point is taken.

What the report contains

• Every feature called up on the drawing, with a measured value rather than a tick.
• The datum order used, so the report can be reproduced.
• The certificate reference for the material and the calibration dates for the equipment.

Common sources of dispute

Most disagreements are about method, not about the part: a warm part, a burr left on, or a datum taken in a different order. Design for a tool with the shortest possible overhang

Applications

Hard Milling is used for finishing hardened tool steel and bearing steel without grinding or EDM, and in practice it appears most often in die and mould work, hardened wear plates, bearing components, cutting tools.

How it fits into a machining route

The route is fixed before the first part is cut, and it is the route rather than the individual setting that holds the result: tool cost, because the cutters are expensive and short lived. Where a drawing calls for something the route cannot hold economically, that is raised at quotation rather than after the parts are made.

Standards, documentation and what is issued

The documentation requirement is in-house approval with dimensional reports. Material is supplied against a certificate where the application calls for it, inspection results are recorded with the job, and the records are kept so that a repeat order can be compared with the first instead of being measured from scratch.

CMM and roughness gauge is the verification step. Where a customer format or a standard report is required, it is agreed before the batch starts, because a report written after the event is a report nobody can use.

Frequently asked questions

What tolerance should be specified for Hard Milling?

±0.01 mm is realistic in production. Tightening it beyond the functional requirement increases cost without improving the part.

Which material is usually used?

H13 tool steel at 52 HRC is the usual choice, supplied against in-house approval with dimensional reports.

How is the result verified?

CMM and roughness gauge, with the results recorded so a repeat order can be compared with the first.

What is the most common mistake?

Expecting a soft machine to hold a hard milling tolerance.

How long does it take and what does it cost?

A realistic cycle is 2 to 10 hours for a cavity, and the cost driver is tool cost, because the cutters are expensive and short lived.

Related capability

If you are specifying Hard Milling on a drawing and want a second opinion on the route, send the model and the quantity. The first response is a manufacturability review with the likely risk points and a quotation, so the decision can be made on facts rather than on a price alone.

Machining, inspection and documentation are handled in one place, which is why the dimensional report and the material certificate arrive with the parts rather than after them.

Related entries

These entries sit next to Hard Milling in the encyclopedia: CNC Turning, High Speed Machining, 7075-T6 Aluminium. Reading them together gives a fuller picture of how the process, the material and the measurement affect each other.