-
Documentation Pack for E-Motor Housing: What Shipped with the Order
The documentation supplied with a shipment of a water-cooled aluminium housing for a traction motor: what each document is for, why it matters at goods-in and how it is kept valid for repeat orders.
Details -
Scheduled Repeat Supply of E-Motor Housing: Planning, Stock and Kanban
A scheduled supply programme for a water-cooled aluminium housing for a traction motor: how releases were agreed, how stock and tooling were held, and how forecast changes were handled without disruption.
Details -
Assembly Fit Check for E-Motor Housing: Machining to the Mating Part
Machining a water-cooled aluminium housing for a traction motor against its mating part: how the fit was defined, checked on the shop floor and then verified at the customer's assembly line.
Details -
Emergency Rework: Recovering a E-Motor Housing Order Against the Clock
An emergency recovery job involving a water-cooled aluminium housing for a traction motor: what went wrong at another source, how we planned the recovery in parallel, and how usable parts reached the customer line in time.
Details -
Material Change for E-Motor Housing: Trial, Validation and Approval
A material change programme for a water-cooled aluminium housing for a traction motor: why the change was needed, how the trial part was machined and tested, and how the new material was validated and approved.
Details -
Design Feedback on E-Motor Housing: Changes Proposed Before Cutting
A design-for-manufacture review of a water-cooled aluminium housing for a traction motor: the features that were expensive to produce, the changes we proposed, and how the function was preserved while simplifying the process.
Details -
Cycle Time Down by 25 per cent: Machining E-Motor Housing
A machining improvement programme on a water-cooled aluminium housing for a traction motor: where the time was going, what we changed in roughing, tooling and handling, and the 25 per cent saving achieved without touching the drawing.
Details -
Batch Repeatability: 5 Units of E-Motor Housing to One Standard
How we held consistent results across a 5-unit batch of a water-cooled aluminium housing for a traction motor: the controls on tooling, offsets and inspection that keep the first part and the last part the same.
Details -
Re-sourcing E-Motor Housing: Taking Over an Existing Programme
How we took over an established programme for a water-cooled aluminium housing for a traction motor: reviewing inherited drawings and samples, rebuilding the process, proving it and shipping the first approved batch.
Details -
Fixture Strategy for E-Motor Housing: How We Held the Part
The fixture strategy behind a water-cooled aluminium housing for a traction motor: how we located the part on its drawing datums, what was built, why those decisions were taken and how the setup performed in production.
Details -
Scheduled Repeat Supply of Industrial Gearbox Input Shaft: Planning, Stock and Kanban
A scheduled supply programme for an alloy steel shaft carrying a gear seat and bearing journals: how releases were agreed, how stock and tooling were held, and how forecast changes were handled without disruption.
Details -
Documentation Pack for Industrial Gearbox Input Shaft: What Shipped with the Order
The documentation supplied with a shipment of an alloy steel shaft carrying a gear seat and bearing journals: what each document is for, why it matters at goods-in and how it is kept valid for repeat orders.
Details
Case Studies
